In the UK insurers always increase premiums when you change the wheels from standard. Is it not the same elsewhere?
Not in my experience at least.
In the UK insurers always increase premiums when you change the wheels from standard. Is it not the same elsewhere?
My number platesWhat plates did you have to remove?
View attachment 11748View attachment 11749
For those who emailed me the last few weeks, Yes, I'm still alive
Rainy weather can be awesome too. Too sad I had to remove the plates and resize the pictures.
This my forum friend is why Micron Grey is THE colour for the i30N. Sorry to those who bought other colours. Prove me wrong and post posts photos as good as these. Ha, challenge set.View attachment 11748View attachment 11749
For those who emailed me the last few weeks, Yes, I'm still alive
Rainy weather can be awesome too. Too sad I had to remove the plates and resize the pictures.


This my forum friend is why Micron Grey is THE colour for the i30N. Sorry to those who bought other colours. Prove me wrong and post posts photos as good as these. Ha, challenge set.![]()


Excellent @padigree. It's actually relaxing, looking at the whole photo.And two more to make "this set" complete
View attachment 11753View attachment 11755
I absolutely love my camera. And I'm glad I was able to take these not only with my phone camera. Sadly I lost many nice pictures from the last years on my phone without any backup. So I have to take some new pictures soon. I'm also happy to get new wheels for summer. Hopefully there will be many events and meetings with frieNds which can be "well documented"![]()
This my forum friend is why Micron Grey is THE colour for the i30N. Sorry to those who bought other colours. Prove me wrong and post posts photos as good as these. Ha, challenge set.![]()
Hello! Can you post a link to this module (disable the Start-Stop system)? You wrote that you bought it on eBay, I could not find it there ...Disabled the Start/Stop ISG with a memory module:
Some pictures of the eBay module:
View attachment 5988
Changed the wire colours for better identification.
View attachment 5989
Wrapped the wires with that fluffy adhesive tape. This prevents the cables from causing noise on the vehicle trim after installation and makes it look much cleaner.
View attachment 5990
Circuit board protected by transparent shrink tubing. This prevents damage due to short circuit.
Video (german) of the installation /HowTo:
It works. The module saves the last state of the vehicle. If the Start/Stop function has been turned off, it will be deactivated after the next start. When turned on, it will turn on again the next time you start up.
Hi can you say me each wire color of those four wires to going connected to subwoofer to what serve each one exactly?A while ago, I swapped the front speakers for HERTZ speakers. The speakers have caused a great improvement of the sound. Since I was missing something in the low-frequency range, last week I installed an active subwoofer (JBL Basspro II). Again Many thanks to @Haba1205 for the nice support ;D
If you want to do this job clean, the N looks like a construction site.
View attachment 3852
When installing I have removed almost all panels, but not the B-pillar. I pushed the cables after I wrapped them up behind the pillar.
View attachment 3853
The most ugly part:I pushed the cable into the engine room first, then attached a cable to it and pulled it inwards. Pull this cable to my power cord and then with this back to the engine compartment. That was a work that was not nice at all.
View attachment 3862
After that, I have the cables laid under the seat in the trunk.
View attachment 3854
On this picture you can see how the cables look wrapped up.
View attachment 3855
On the passenger side, I have also laid a line for the volume control. This could now be checked in the glove box.
View attachment 3856
The connection to the battery I have made with a fuse holder. The fuse should only be used when the other connections are ready.
View attachment 3857
Here you can see the mess. I also insulated the luggage compartment with alubutyl, because the spare wheel well is very thin and produces unpleasant vibrations.
View attachment 3858
View attachment 3860




