-
Welcome to N-cars.net - the largest Hyundai N car forum. Check out the model specific sections below and scroll down for country specific forums. Scroll down for i30 N, Ioniq 5 N, i20 N, Veloster N and Kona N forums! Check out the i30 N Bible Here!
TarmoT 385bhp/526Nm i30ntracktoy - SOLD
- Thread starter TarmoT
- Start date
Thanks for a link, I didn´t know about that.
The exhaust is built into the diffuser, that looks grand @Tarmo !!. A sound bite please when you have time!!
. A sound bite please when you have time!!
After they defect everything to hellIndeed, would put the Stingers to shame as a pursuit car
Today I am going to pick it up and tomorrow is booked for CAE installation.
Next week car goes back to RCP and they will install back improved roll gage and give final finish for exhaust.
Same time I must find out how to make these two metal bars to disappear from centre section of diffusor.
Cannot wait to hear about the cae installation! Are you still going to keep the Forge short shifter brackets too?
WE need a WRC launch!! ..........No not really. I can't do two or more likes but they're already there if I could.
@ TarmoT Ooooh, I like this on both occasions. The CAE is short and very positive. Impressions of shifting, please? Tell us about the CAE install when you have time. I've very interested in the install process.
..........No not really. I can't do two or more likes but they're already there if I could.@ TarmoT Ooooh, I like this on both occasions. The CAE is short and very positive. Impressions of shifting, please? Tell us about the CAE install when you have time. I've very interested in the install process.
CAE installtion to i30n is different than to VN because centre console is different.
I installed it by myself and without using that manual they have on their home page. It is only in German language. I did not need to make any adjustments but moved Forge short shifter to middle setting. Cuting centre console was a bit complicated because there was no template provided. Same situation with those 2 12mm holes you should drill to centre tunel. But it took me 5-hours and it is done now.
I installed it by myself and without using that manual they have on their home page. It is only in German language. I did not need to make any adjustments but moved Forge short shifter to middle setting. Cuting centre console was a bit complicated because there was no template provided. Same situation with those 2 12mm holes you should drill to centre tunel. But it took me 5-hours and it is done now.
Until next updates regarding Hyundai, one picture from my new daily driver: