i30N E - LSD (e diff) in 2024

[V0LANT]

Hello,

For past two days i gather info about the LSD. to be more specific about its Oil bath and potecional change.
Here is for sure a lot of information, but when it comes to oil change it allways end up on "lifetime fill". How ever those post are from 2018 - 2022 and i wanna ask, Did someone change the Oil in their diff ? if yes, please how, i allready learn about the fact Fluid specified is SHELL TF0870 and it should be injected somehow, but i really dont know HOW.

Thnak you very much and also sorry for gramar errors, im not native english speaker.

 

[Bu11eT]

Oil specs: Shell TF 0870B

Translation:
1. Remove the servomotor
2. Drain the oil into a clean measuring cup
3. Determine the amount of oil filled (approx. 50ml)
4. Fill approx. 50 ml of new oil into the e-LSD unit
5. Reinstall the servomotor A: the plug connection (D) should point to the left
6. Remove the bleeder valve (not sure if necessary, requires special tools)
7. Install a new bleeder valve (Part No: 47349-3B000) (not sure if necessary, requires special tools)
8. Reinstall the e-LSDunit again and then carry out a test drive

 

[V0LANT]

Oil specs: Shell TF 0870B

Translation:
1. Remove the servomotor
2. Drain the oil into a clean measuring cup
3. Determine the amount of oil amount of oil filled (approx. 50ml)
4. Fill approx. 50 ml of new oil into the new oil into the e-LSD unit
5. Reinstall the servomotor A: the plug connection (D) should point to the left
6. Remove the bleeder valve (not sure if necessary, requires special tools)
7. Install a new bleeder valve (Part No: 47349-3B000) (not sure if necessary, requires special tools)
8. Reinstall the e-LSDunit again and then carry out carry out a test drive

Thnak you sir, you are an Absolute legend!

 

[TSiekansky]

Hi! Ive got a leak from mine eLSD, 2019 i30N performance manual transmission. Does the oil spec apply to all models?

 

[Cachibaxe]

Oil specs: Shell TF 0870B

Translation:
1. Remove the servomotor
2. Drain the oil into a clean measuring cup
3. Determine the amount of oil filled (approx. 50ml)
4. Fill approx. 50 ml of new oil into the e-LSD unit
5. Reinstall the servomotor A: the plug connection (D) should point to the left
6. Remove the bleeder valve (not sure if necessary, requires special tools)
7. Install a new bleeder valve (Part No: 47349-3B000) (not sure if necessary, requires special tools)
8. Reinstall the e-LSDunit again and then carry out a test drive

The images explain how to change the fluid, but if you only want to add some because it's leaking from the pressure sensor, wouldn't it be enough to just add a little from the same hole where the pressure sensor is located?

My English is thanks to a translator, sorry.