• Welcome to N-cars.net - the largest Hyundai N car forum. Check out the model specific sections below and scroll down for country specific forums. Scroll down for i30 N, Ioniq 5 N, i20 N, Veloster N and Kona N forums! Check out the i30 N Bible Here!

i20 N front undertray

Toggle sidebar Toggle sidebar
I've seen the workshop manual being shared (god bless the member who downloaded every single section in PDF and shared it here with us) but haven't seen an official parts catalogue in pdf format.

There's this though, it was shared in how to section. Take a look. Maybe you'll find it.
 
Thays brilliant thanks very much, ties up with a part number for a new one on ebay
I dont know if anyone has seen the problem but after les than 28k miles half the retaining fasteners for the undertray and wheel arch protectors are either very loose or missing, a bit pathetic to be honest and I'm sure that's why my undertray came loose and wrecked itself
 
Stace said:
Thays brilliant thanks very much, ties up with a part number for a new one on ebay
I dont know if anyone has seen the problem but after les than 28k miles half the retaining fasteners for the undertray and wheel arch protectors are either very loose or missing, a bit pathetic to be honest and I'm sure that's why my undertray came loose and wrecked itself
Click to expand...
 
In general, all the plastic fasteners in the wheel arch area and also bumper areas are very loose on the i20n. Also for me very annoying.

We could sort out little bit thicker clips that fill out the holes more tightly but at this point I am to lazy to do that. But maybe in the future
 
  • Like
Reactions: i_twenty_N
X-i20N said:
In general, all the plastic fasteners in the wheel arch area and also bumper areas are very loose on the i20n. Also for me very annoying.

We could sort out little bit thicker clips that fill out the holes more tightly but at this point I am to lazy to do that. But maybe in the future
Click to expand...
I'm buying some 6mm U lug captive nuts to replace the 4 front clips and fastening it with socket button head screws and washers.
the only issue is making sure they pull the undertray up flush
 
U lug nuts
I have learned a new word cool.
In Germany we call them Blechmuttern.
I have some of these in different sizes in sdash, so maybe I sort out some optimizations with them.
You should try grabbing and moving for and back the rear bumper lower section. Crazy how loose this is and imagining it's parachute behaviour on a German Autobahn or racetrack
 
Can you please share a picture from your underbody problem?
I don't know the shapes and clips etc in detail but I am afraid the solution with U lug nuts won't work at every clip position
 
It's scary how cheaply made this car is in some areas. It seems to be the general trend in automotive nowadays though. I hope this is not the case for where it counts.
 
You must log in or register to reply here.

Top Bottom