Spacers fitted photos set 1

[RIGPIG]

Finally found some spacers that fit I5N M14 wheel studs. They are from Bonoss in China. Not cheap - they cost $380 for a set of 4 shipped air freight to US. They look like well made kit. Here is some before and after photos. I think the 15 mm offset is just about right. I'll put another post or thread with more photos.

 

[RIGPIG]

See if I can put more photos here.

 

[Kirtap]

Looks great! Have you noticed any downsides running these spacers?

I have a 5N arriving in May and I’m leaning towards 21x9,5 ET30 wheels for summer. Stock wheels will get studded winter tires!

 

[RIGPIG]

No she runs just the same as before the spacers as far as I can tell. Since that post I removed the goofy plastic pieces and now it looks like a proper wheel. Even less need for aftermarket IMO. But I dont need winter set up either.

 

[Kirtap]

No she runs just the same as before the spacers as far as I can tell. Since that post I removed the goofy plastic pieces and now it looks like a proper wheel. Even less need for aftermarket IMO. But I dont need winter set up either.
View attachment 26355

That's good to hear! I agree with you on the goofy plastic pieces, looks so much better without! I'm sure one loses a tiny little bit of range with them off, but it's definitely worth it.

Taking them off will make it a lot easier to remove snow stuck in the wheels too, haha!

Thank you very much!

 

[NRGFIVE]

Bonoss sells Terrific products!
Very well made and they ship quickly!
Ran their product on both my A90 Supra and Q8 Etron S.

 

[Genestealer]

No she runs just the same as before the spacers as far as I can tell. Since that post I removed the goofy plastic pieces and now it looks like a proper wheel. Even less need for aftermarket IMO. But I dont need winter set up either.
View attachment 26355

Do you have a picture of the whole car without the goofy plastic pieces?

 

[RIGPIG]

Do you have a picture of the whole car without the goofy plastic pieces?

 

[e-I5N]

Here are plugs to fit the mounting holes in the wheel spokes upon removal of plastic. This was a lot of research.

https://www.amazon.com/dp/B0F3DBDM1P?ref=ppx_yo2ov_dt_b_fed_asin_title

Tried to attach photo, but too big. PITA

 

[e-I5N]

pic

 

[RIGPIG]

pic

Looks good, thank you!

 

[Rodtheviking]

Just order the 20mm/15mm set from Bonoss, nice product. I'll get those plugs too, didn't know what to do about the little holes. Thanks.

 

[ALCOBENDAS]

Hi, thanks for all the information posted. My only question is whether 15mm or 20mm looks more "flush" at the rear. At the front, it's clear to me that 15mm is already quite a lot.
@

RIGPIG​

 

[MountainPassPerformance]

Amazing what a bit of good stance can do for a car's look. This looks way better!

 

[RIGPIG]

Hi, thanks for all the information posted. My only question is whether 15mm or 20mm looks more "flush" at the rear. At the front, it's clear to me that 15mm is already quite a lot.
@

RIGPIG​

I think the 15 is as much as I would want to have it look good but stil vaguely factory. To me 20 might be enough to make it look like ill-fitting wheels, or too obviously spaced out.